 |
SPOT WELDER
Light weight portable this easy-to-use spot welder welds uncoated mild steel materials
up to 2.5mm - 5.0mm. This air-cooled unit plugs into any standard
230V outlet to proide quick and effective welds on mild
galvanized or stainless materials.
Hand lever locks tongs family on material, ensure positive,
accurate fit-up
- Accommodate a wide variety of tongs and tips
- Quick and easy adjustment for material thickness
- Reversible for left or right hand operation
- Includes 152mm /6 inches/, and – 203mm/8 inches/ and 305mm/12 inches/ tongs with tips
|
Technical Information
| Capacity /KWt/ | 1,5 | 2,5 |
| Entry tension /V/ Single-phase | 120/230 | 120/230 |
| Frequency | 50/60 | 50/60 |
| Maximum exit current /Amp/ | 5500 | 6500 |
| Working cycle / % / | 50 | 50 |
| Thickness of welded sheets /mm/ | 2,5 | 5,0 |
| Sizes /mm/ | 368x153x114 | 406x153x114 |
| Weight /kg/ | 11,0 | 16,0 |
|
 |
DENT REPAIR STUD WELDER KIT
Instantly spot welds copper-plated studs to dinged body
panels.
Includes a 1Kg slide hammer for gripping studs and pulling
dents.
Comes with one hundred
2mm and 3mm steel copper coated studs and 1 extra 3mm welding electrode.
- "D" Handle for precise control
- 1-3 seconds switch depression
- Reset table safety breaker
|
Technical Information
| Capacity /KWt/ | 2,5 |
| Entry tension /V/ Single-phase | 120/230 |
| Frequency | 50/60 |
| Working cycle / % / | 1 |
| Welding time /sec./ | 1-3 |
| Weight /kg/ | 7,0 |
|
 |
STITCH WELDER
This easy to use STITCH WELDER attaches to any conventional A/C Arc Welder permitting welding on sheet metal as thin as 22 gauges. Welding with the stitch welder is faster and easier than conventional stick welder with less chance of burning through or warping sheet metal.
Depending on your brand of welder you have to set your welder 55-65 apms to successfully weld sheet metal.
|
 |
SPOT WELD GUN
This easy to use Spot Weld Gun welds two overlapping steel panels (up to 18 gauges) together using an
electric arc to melt the top panel, fusing it to the bottom panel.
The two panels must be cleaned of all rust, paint, grease or other material, and must fit tightly
together-this is critical to both the strength of the weld and achieving satisfactory results.
Spot Weld Gun attaches to most Arc (stick) welders and uses 55-65 amps, making it possible to
weld light gauge sheet metal (such as auto body panels) with virtually none of the distortion usually
caused by high powered stick welder.
Include 2 graphite electrodes.
|
